| Dualsky Summit 30X 6V SBEC ESC Specification | |
|---|---|
| Continuous current | 30A |
| Burst current | 45A |
| Battery | 2S - 6S LiPo |
| SBEC | 3A @ 6V, 6A peak |
| Weight inc leads | 24g |
| Firmware | BLHeli-32 |
| Programmable | Yes, with an Arduino or our BLHELI-USBprog interface |
| PCB Size | 47mm * 17mm |
| Battery connector | 8 cm wires, XT30M plug fitted |
| Motor connector | None (lands on PCB) |
| RC wire length | 12 cm |
| Telemetry | Yes |
Review by: Sir Bob
Nice little ECU especially small for 30amp.I’ve actually had 3 of these. One for me and the others two were fitted to models I’ve built for other people. They work really well and the 6 volt output is a good compromise if you are using HV servos. I did find one problem. If you are using a 2 cell setup, I found the motor would not start reliably. I discussed this with Neil and he suggested that the minimum voltage be reprogrammed to 2.7 volts per cell. I sent the units back to him and he adjusted them accordingly and now that problem has gone away. They were returned promptly. The issue did not occur when using 3 cells.
I haven’t tried the telemetry yet but will will see how that goes. They appear very well made.
447821351341
sales@hyperflight.co.uk
Contact Form
